Frida Floral Wall Decor

Elevate your home decor with our exquisite Frida Floral Wall Decor. This stunning piece adds a touch of beauty and elegance to any wall, car or furniture. The vibrant floral design showcases the iconic Frida in all her splendor. A must-have for any art enthusiast.

1 - Prep Your flat smooth Surface and Pre-Squeegee Your UV-DTF Permasticker

Prepping the Area - When necessary, clean the surface of your item before applying the PermaSticker using a cleaning solution that works for your product and make sure it is dry before applying. This helps it endure natural elements, washing, and wear and tear. Although it will adhere well without it, it is recommended.

Pre-Squeegee - After cutting your sticker/decal out, place the design face down with the white side facing up. Using the padded end of the included squeegee, run over the whole design with hard pressure, back and forth 2-4 times.

Additional pressure and repetitions should be applied on thin and separated design elements, such as small text.

2 - Separating the Upper Clear Carrier Sheet From the Backing

To detach the upper clear carrier sheet from the backing, making a small tear on the outer edge of the transfer makes this easier. Gently peel the upper clear carrier sheet, watching to ensure the whole design lifts off the backing. We have a saying in the Dojo - Don't peel with your hands, peel with your EYES. For designs which contain thin lines and small separated elements, such as small text, the slower you should peel. If parts don't lift, re-squeegee, and attempt to peel again from a different angle. You'll get a feel for this with experience.

3 - Placing Your UV-DTF PermaSticker Onto Your Item First, identify the placement area on your item.

For smaller designs (4 inches & under), carefully place the design onto the placement area with two hands controlling the placement.

For larger designs (6 inches & larger), place with two hands or you may find it easier to place the sticker starting from one side and ending at the other. Use whichever method helps you control your placement, reduce bubbles underneath the design, and avoid wrinkling of the carrier sheet which could cause design elements being offset and/or design overlapping.

Tip: Leave a corner of the carrier sheet unpressed to the product for easy peeling. For example:

4 - Completing the Transfer Process

After placing the design, firmly squeegee it 2-4 times. Peel slowly, watching to ensure all elements stick. Again, the lesson from the Dojo applies here - use your EYES and not just your hands. If any part of the design is not adhering, lay the carrier sheet back down, re-squeegee and try peeling from a different angle. You'll get a feel for this with experience as well.